Pulsafeeder MPC Vector Manuale Utente Scaricare il pdf (Pagina 22)

6.7 Flow Display

The MPC VECTOR will display calibrated pump flow in GPH, LPH, GPM, or LPM on the digital display

when configured for flow control. The motor speed (in RPM) may also be viewed while in flow control.

Changes to the flow units are made in the System Setup Menu.

6.8 Wrapping up

Your MPC VECTOR is now commissioned for use. Note that you cannot configure the software in a way

that would damage the MPC VECTOR. Typically, whenever you are about to set a critical value (e.g.,

Calibrate Flow), you are always prompted to confirm your change before it takes effect. If you are ever

dissatisfied with the configuration of your MPC VECTOR, you can always return to the Factory Defaults by

referring to Section 6.7.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 69 70

Nessun commento

Pulsafeeder MPC Vector Manuale Utente Pagina 22